Connect and playback from a digital
device (Coaxial/Optical)
1
Press OPT/COAX to select the input source to
“Coaxial” or “Optical”.
The digital audio signal that is being input is shown as follows in the
display.
“Coaxial
or
“Optical
PCM xxxx kHz”
PCM xxxx kHz”
(xxxx is the sampling frequency.)
0
If the sampling frequency cannot be detected, “Signal Unlock” will
be displayed.
0
“Unsupported” is displayed when audio signals that are not
supported by this unit are input.
o
Files that can be played back
See “D/A converter” (
v
p. 110).
NOTE
0
Do not input non-PCM signals, such as Dolby Digital, and DTS. This causes noise
and could damage the speakers.
0
If the sampling frequency switches, such as from A mode to B mode in a CS
broadcast, muting may operate for 1 – 2 seconds, cutting the sound.
Contents
Connections
Playback
Settings
Tips
Appendix
84
Front panel
Rear panel
Remote control
unit
Index