JIG FOR SERVICING
When you repair the printing board, you can use the following JIG (Extension cable kit).
Please order it from Marantz Official Service. Distributor in your region if necessary.
NOTE
: The incorrect connection with in the JIG (EXTENSION UNIT KIT) may cause damage.
• Connection of PCB HDMI JIG
-Preparation-
8U-110084S : EXTENSION UNIT KIT : 1 Set
8U-110136S : EXTENSION UNIT KIT : 1 Set
Insulation sheet (Do not supply it)
: 1 sheet
Ground lead (Do not supply it)
: 1 pc
-Procedures-
(1) Remove the screws, then remove the BACK PANEL.
(2) Disconnect the connector board.
Shooting of photograph: A
Board to board
PCB HDMI
48