16
PLAYBACK
ENGLISH
HP/SPK MODE
BACKSPACE
1¥4 ¢¥¡
DISPLAY
PLAY/PAUSE (
6
)
Operation
To start playback
Press PLAY/PAUSE (
3˜8
) during stop mode.
To pause during playback
Press PLAY/PAUSE (
3˜8
).
Press again to resume playback.
When operating from battery power, the power
management function automatically releases the pause
and turns the power off after 5 minutes.
To switch the information shown in the display
Press DISPLAY repeatedly.
(See “Viewing the date and time” on page 9 for details.)
To stop playback
Press STOP (
7
).
Playback stops automatically at the end of the last track.
Note
When operating from battery power, the power management
function will automatically turn the power off after a certain
amount of time if the unit is left in pause mode.
BACKSPACE
To go back a few seconds, press BACKSPACE.
Play skips back 5 seconds, then continues.
Press repeatedly to skip backward in additional 5 second
increments.
Notes
• BACKSPACE only operates within the current track.
• When BACKSPACE is pressed at a point less than 5 seconds
from the beginning of the track, playback starts from the
beginning of the track.
Quick playback
During stop or play-pause mode, press
¢˜¡
while
holding down the PLAY/PAUSE (
3˜8
) button to start
quick playback (playback at about twice normal speed).
Press PLAY/PAUSE (
3˜8
) again to resume playback at
normal speed. (Please note that BACKSPACE does not
function during quick playback.) The repeat play is not
possible during quick playback.
Basic Operation
Playback can be monitored through the internal speaker
or a pair of headphones. Use the HP/SPK VOLUME knob
to adjust the level of the internal speaker or headphones.
The audio signal is also output from the LINE OUT jacks
and DIGITAL OUT jack (if DIGITAL OUT is ON). The
signal level of these jacks is not effected by the HP/SPK
VOLUME knob.
Preparation
HP/SPK MODE
Select L (left channel), STEREO (left and right channels in
stereo), or R (right channel) according to the channels you
want to monitor through the internal speaker or
headphones.
Notes
• When headphones are connected, no sound comes from the
internal speaker.
• When using headphones and playing back a dual level mono
recording with HP/SPK MODE set to STEREO, the sound
from the right channel will be –15 dB lower than the sound
from the left channel.
• When using headphones and playing back a normal mono
recording with HP/SPK MODE set to STEREO, the same
sound is output from both channels.
• To cut output from the internal speaker (when headphones
are not connected) set the HP/SPK VOLUME knob to “0”.
SOURCE
SP
LP
OFF
ON
REC MODE
0dB
-15dB
MIC ATTEN
FLAT
ANC
-30dB
MIC
LINE
INPUT LEVEL
INPUT SELECT
STEREO
HP/SPK MODE
REC LEVEL
LSR
MANUAL
STEREO
INT MIC
L
R
MONO (L ch)
ANALOG
DIGITAL
LIMITER
ALC