E
N
G
LI
S
H
10
RC9001 will not learn codes
• Make sure the Control Panel and the original remote control are positioned correctly.
• Do not learn codes under bright fluorescent light or sunlight, as intensive light sources affect the
ability to learn codes successfully.
• Make sure the batteries of the Control Panel and the original remote are sufficiently charged.
• Press and hold the key on the original remote for more than one second.
The A/V equipment does not respond to commands from the Control Panel
• Make sure you have defined the correct codes for your A/V equipment.
• If you want to use RF signals for the equipment on different locations, you need to use multiple
Extenders in the Wireless Network. You need to configure the Extenders:
•
On the Extender hardware by assigning an ID with the
Extender ID switch
.
•
In
Wizz.it Ex
by defining the number of Extenders in the
System Properties
and matching
the Extender to the A/V component in the
Device Properties
.
•
When the Extenders work in a network, you need to configure the Network Settings in the
Configuration Tool
.
For more information, check the User Guides for the RX9001 and RX8001 Extenders and the
Wizz.it Ex Online Help.
• When the Control Panel works in a WiFi environment, bear in mind that it may take the Wireless
Network a few seconds to wake up and starts transmitting codes.
• Not all Wireless Access Points are working equally well in combination with the Control Panel.
Make sure you use a quality access point.
The transmission of the signals over the wireless network is slow
Depending on the Settings you made for the Network Settings, it takes longer for the Wireless
Network to transmit signals. The variables in the Settings are:
•
The location of the Wireless Access Point
: To test if the Wireless Access Point and the
Control Panel are too far apart, take the Control Panel and stand closer to the Wireless Access
Point.
If the transition is significantly faster, place the Wireless Access Point closer to where the
Control Panel will be used or add an extra Wireless Access Point in the Wireless Network.
•
Encryption
: The encryption used by the Extenders and the Control Panel slows the transition of
the signal down.
•
The chipset of your Wireless Access Point
.
•
The DHCP server settings
.
Caution
If you change the DHCP Settings to accelerate the transition, you also need to adjust these
settings on the Extenders used in the Wireless Network with the
Configuration Tool
.
The Control Panel shows one of the following icons
RC9001 User Guide
No connection
• The Wireless Access Point is powered down.
• The Control Panel is out of range of the Wireless Access point.
• There is an encryption problem.
No identification
• There is no IP address received.
• An IP conflict is detected.
