4. Protection Pass Mode
4.1. Actions
• This mode allows the power to be turned on without activating protections.
• This is the same as normal power-on, except that protections are not activated.
4.2. Operations
Hold down buttons "
DIMMER
", "
STATUS
" and "
SOUND MODE
" at the same time and press the power button to turn on
the power.
The device returns to the normal display after the following is displayed.
FLD
L1
P r o t e c t
L2
P a s s
L3
This is displayed for 5 seconds before returning to the normal display.
5. CX870 / CY920 Reboot mode
5.1. Actions
• The CX870 / CY920 is restarted after CX870 / CY920 hangup.
• The CX870 / CY920 can be restarted even in the network standby setting ("
Setup menu
" – "
Network
" – "
Network
" –
"
Always On
").
5.2. Operations
1. Turn on the button "
MAIN ZONE
" and set NETWORK as the input source.
2. Hold down buttons "
TUNER PRESET CH +
" and "
STATUS
" for at least 3 seconds while the power is on.
3. FL display during CX870 / CY920 reboot
FLD
L1
N e t w o r k
L2
R e s t a r t
L3
4. Returns to the normal display.
NOTE:
• The CX870 / CY920 Reboot operation is not accepted again for one minute after executing the reboot.
• Reception is prohibited during update, save and load.
51
