ENGLISH
2
Rubber mat
Platter
OFF
ON
Center spindle
Equalizer switch
Platter
Ribbon tape
Driving roller
Drive belt
1
2
3
4
n
Important (Please check this.)
A drive belt and a ribbon tape are attached on the underside of the
platter. Take hold of the ribbon tape and hook it onto the driving roller
as shown in the figure.
Assembly
Before assembly, remove all packaging material except for the plastic
tie securing the tone arm and open the dust cover. Leave the plastic
tie securing the tone arm until assembly is complete.
1
Set the equalizer switch to the appropriate position
for the type of input terminal on the device connected
to the TT5005.
ON
When connecting to an AUX input terminal or an input
terminal other than “PHONO” (default setting at time of
purchase).
OFF
When connecting to a PHONO input terminal.
2
Mount the platter on the center spindle.
Turn the platter so that the drive roller is visible through the
opening in the platter.
3
Take hold of the ribbon tape attached to the drive
belt on the underside of the platter and hook the
drive belt onto the driving roller.
• Remove the ribbon tape after hooking the belt onto the roller.
• Turn the platter by hand until the drive belt is positioned at
the center of the driving roller.
4
Place the rubber mat on the platter.
NOTE
If the equalizer switch is not set correctly, the sound will be extremely
weak or distorted.
Changing the Stylus
The stylus supplied with the TT5005 has a life of approximately 400
hours. Be sure to replace it in good time to avoid damaging your
precious records.
n
Before replacing the stylus
Unplug the player at the wall socket.
Removing the Replaceable Stylus
Hold the cartridge steady with one hand, grasp the stylus
with the other hand, push down in the direction of arrow
q
and then gently pull the stylus off in the direction of
arrow
w
.
1
2
Cartridge
Stylus
Mounting the Replaceable Stylus
Hold the cartridge steady with one hand, grasp the stylus
with the other hand, point the catch on the stylus in the
direction of arrow
q
and insert it fully into the long
opening in the cartridge, then push up in the direction of
arrow
w
until it clicks.
2
1
Stylus
Cartridge
n
Cleaning the tip of the stylus
The tip of the stylus is extremely delicate and should be handled with
great care. Use a soft brush to gently remove any dust from the tip.
1.TT5005N_ENG_NEW.indd 2
2012/04/13 16:47:26
