PLAY/RECORD
is the next sub-menu; this is where all recording and
playback functions are done.
LIVE
is the first option, this gives you a real-time video and sonar feed of what’s going on
below you.
SIMULATOR
The LX-9 has a simulator mode that will portray a variety of different depths and
signal returns. Activating this feature enables the user to experiment with the various settings
without actually being on the water. To activate, highlight SIMULATOR and press MENU/
ENTER. To turn off the SIMULATOR, you must go back to the PLAY/RECORD menu,
highlight and select LIVE. This simulator represents an open water experience, so the depths
and signals will change as it goes through the simulation.
PLAYBACK
is to review video recordings you have made. The recordings will display as
boxes identified numerically. Use the UP and DOWN arrows to highlight the desired clip, then
select MENU/ENTER. A small white triangle will appear in the lower right corner during
playback, and will change to a white square at the end of the clip. After a video clip has been
played, the last frame of the video will remain on the display until you press any button. You
will then be returned to whichever “View Mode” you were in. If you don’t watch a recording to
its end, make sure to stop the recording before moving on to other clips or going back to LIVE
mode. To do this, first press MENU, choose Playback/Record, highlight “STOP”, and finally
press Menu/Enter.
To playback a video, make sure that you are not in “Sonar Mode”, but have selected “Camera
Mode”, “Heads Up Mode” or “Split Screen Mode”. If you recorded Sonar signals, they will
playback on whichever Sonar Windows you have open.
RECORD
is to begin a recording. A red circle will appear in the lower right corner of the
display while a recording is being made.
STOP
(Playback/Record) is to stop a recording or to stop a Playback clip.
DELETE
will bring up a page similar to the playback page. To delete a clip, you must first select
DELETE, then scroll to the desired recording you want deleted. The highlighted video will be
deleted when you press MENU/ENTER.
EJECT SD CARD
should be set to “on” before you remove your SD card.
-10-
Versa Electronics
www.marcumtech.com