Versa Electronics
www.marcumtech.com
Getting Started
Your new Showdown 5.6 Digital Fish Finder comes completely assembled, and
nearly ready to use. Follow the simple steps below and you will be ready to
fish.
(1)
Remove the ShowDown 5.6 from the box. Gently remove the entire unit
from the neoprene case. Your ShowDown should be firmly attached to a clear
gimbal bracket.
(
2)
Make sure all wire connections are solid.
(3)
Make sure that the round rubber stopper is securely in place on the trans-
ducer cable, and that the hook and loop battery strap is tight to keep battery
snug in the battery compartment.
(4)
Slide fully assembled Showdown 5.6 back into the neoprene case.
(5)
The 9 amp battery provided comes with a good charge on it and can be
taken fishing upon opening the box. Before initial use, you may want to charge
it fully if you are not going fishing immediately. To charge the battery, see
below.
(6)
Route transducer cable through the adjustable transducer turning arm.
Affix rubber cable stopper at the desired depth above transducer.
(7)
Place your Showdown 5.6 on a relatively level spot on the ice, extend the
transducer arm over ice hole, place the transducer into the water, and turn
the unit ON by pressing the POWER key.
(9)
To store your ShowDown, turn power OFF, fold in transducer arm, tuck
transducer into interior mesh pocket, and fold hook and loop closure over.
Remember to recharge battery after every use—this will maximize run time
and battery longevity.
- 4 -
