INSTRUCTIONS AND WARNINGS
FOR INFRARED HEATING PANELS
MAREX Solutions
For cleaning you go best by executing the following steps:
• Before cleaning, pull the plug off.
• The heater is very hot after use (depending on model, up to 125C, BURNING DANGER).
Before you clean the heating element, let it cool down first (about 10 to 15 minutes).
• Do not immerse the heating panel for cleaning into water or spray it off. Never use a wet cloth.
Clean with a duster or slightly dampened cloth. Make sure that the heating element is completely
dry before re-commissioning.
• Do not use abrasives or other harsh cleaning products or rough cloths. Wall heaters with
pictures clean dry only.
• For ceiling panels occasionally remove any dust on the top with a vacuum cleaner.
3.5. INSTRUCTIONS FOR REPAIR
• In case of irregularities of the devices, always contact
us or
your dealer and do not repair by yourself.
• If a malfunction occurs, immediately disconnect the power cord. Do not use or stop use
immediately if the unit is damaged, especially if network cable, housing or heating panel itself are
affected.
• In addition, we ask you, to carefully read the described details in section 8 about the details and
processing of warranty cases.
• Never remove the label and the warning sticker. The data on the nameplate are of importance
for the warranty.
4.
TECHNICAL DETAILS
The following information provides general information applicable to panel heaters. Please note
additional information on performance,
and
size at the sticker on the back of
your panels.
5.
ENVIRONMENTAL PROTECTION
