INSTRUCTIONS AND WARNINGS
FOR INFRARED HEATING PANELS
MAREX Solutions
burns.
• Each
MAREX IR
HEATING panel heater is equipped with a power cord and plug. By using an optional
adapter you can operate the heater with room thermostat. Make sure that nobody can trip over
the cable. Protect the unit from overloading the network security protection and operate the
equipment only as specified on the nameplate.
• Do not use the heating panel when the power cord or plug is damaged. This should be checked
before each use. Drag or not to tear the mains cable. Do not scrub the cable to edges and do not
clamp the cable. Neither the cable nor the plugs may be repaired or replaced. In case of damage
contact the manufacturer or his service.
• Never dip the heating panels into water or put it in water. Also, the heating element has never
been touched by persons who are in the bathtub or under the shower. Not use this device near a
bathtub, a shower or a swimming pool.
• The heating panel can only be set in operation in permanently mounted condition (for more
information on mounting, see Item 3.1).
• In case of damage of the heating panel or the network cable, immediately disconnect from the
network and keep it safe (for further information about warranty process, see Item 8).
• Never open the device to prevent damage and accidents (especially look at the detailed
information described in section 3.5.). If the device was not opened by experts, warranty and
liability claims are not approved.
3.
INSTRUCTIONS FOR INSTALLATION AND USE
3.1.
INSTRUCTIONS FOR MOUNTING
MAREX
IR
HEATING panels must be mounted with the supplied
original suspension
(aluminum profiles
at the back of the panels and screws included). For panels that are used without the original
suspension, the warranty and liability are excluded as well as consequential damages.
MAREX IR
HEATING panels must only be used in the manufacturer-related frames. For panels that are
used without the
original frame
warranty, liability and damages are excluded. The following
instructions for your own frame solutions are for informational purposes only and should not be
