Introduction
Thank you for purchasing your new KingPin Anchor system. Please read
through these operating instructions so you will know how to install and
operate your model properly.
Safety Precautions
The safety precautions for this KingPin Anchor system have been pre-
pared to assist the operator in the performance of good safety proce-
dures.
Warning!!
Only engage KingPin Anchor pole when stopped. NEVER MOVING.
Disengage KingPin Anchor pole before moving the watercraft. ALWAYS
be aware of your surrounding while moving with KingPin Anchor pole in
its mount. Take CAUTION around bridges, low hanging trees, power
lines, Etc. Make sure KingPin Anchor pole is securely stored before
trailering boat. Always use the comfort grips while handing the KingPin
Anchor pole. Never step on the KingPin Anchor mount. Take CAUTION
articles of clothing could get snagged on the KingPin Anchor mount.. Use
caution while docking with KingPin Anchor mount attached to watercraft.
FAILURE TO HEED TO ANY OF THESE INSTRUCTIONS MAY RESULT
IN DAMAGE TO YOUR KINGPIN ANCHOR SYSTEM, WATERCRAFT,
AND/OR SERIOUS PERSONAL INJURY OR DEATH.
(1) 5 or 10 In. Transom (4) O-Rings 5/8” (4) Machine Screws
Kit Includes
*Note: Kit does not include the (2) Rubber Pole Clips shown below.
Installing the KingPin Anchor
Required Tools For Installation
13/64” Drill Bit
Phillips Bit
Power Drill
Marker
1.) First use the base of the anchor as a template for marking hole
location.
Watercraft
2.) Drill holes using a 13/64” drill.
3.) Place 5/8” O-Rings in countersink grooves on the boat
side of Base Plate.
4.) Align and secure anchor with machine screws. CAUTION
over tightening may cause screws to strip.
The hardware installation is complete. Your KingPin Anchor is
ready for use.
13/64 Drill Holes
5/8” O-Rings
Machine Screws
Base Plate
* Included with Pole Kit Only
