13
Two-Voice Pro QuickStart Guide
Keyboard Modes
To use Unison/Split “Legato”
This mode is monophonic - each new pressed note replaces the previous one without re-triggering the enve-
lopes. After the first release, nothing happens on other released notes.
To enable this mode:
• Press “UNISON” or “SPLIT” - the LED must be ON solid with RE-TRIGGER OFF.
Unison/Split “Retrigger”
This is the same as the previous mode with but with “RE-TRIGGER” LED on. This mode is monophonic - each
new pressed note replaces the previous one with re-triggering of the envelopes. After the first release, nothing
happens on other released notes.
To enable this mode:
• Press “RE-TRIGGER.”
Unison/Split “Play on Release, Legato”
This mode is monophonic - each new pressed note replaces the previous one without re-triggering the enve-
lopes. If several notes are pressed, releasing one of them plays the previous note pressed without re-triggering
the envelopes.
To enable this mode:
• Press “UNISON” or “SPLIT” – the LED must be flashing.
Unison/Split “Play on Release, Retrigger”
This mode is monophonic - each new pressed note replaces the previous one re-triggering the envelopes. If
several notes are pressed, releasing one of them plays the previous note pressed, re-triggering the envelopes.
To enable this mode:
• Press “RETRIGGER”.
Polyphonic 2 Voice Toggling
The first note pressed after enabling this mode will play SEM A. The next note pressed will play SEM B. The third
note pressed will play SEM A, etc. This mode of operation is sometimes called “ROTATE” mode.
To enable this mode:
• Press “SEM A FIRST” until the LED is off.
Polyphonic 2 Voice SEM A First
The first note played after setting this mode will play the SEM A. If this note is kept pressed, all other notes will
play the SEM B by replacing the previous note as long the first note is not released. If the note playing SEM B is
kept pressed, all other notes will play the SEM A by replacing the previous note.
To enable this mode:
• Press “SEM A first” - the LED must be ON continuously.