7
Two-Voice Pro QuickStart Guide
MIDI
An external MIDI keyboard connected to the TVS-PRO can also be used to transpose sequences. Make sure that the KEYB TRANS
button is enabled on the TVS-PRO.
An external keyboard connected to the TVS-PRO’s MIDI IN port supports the following TVS-PRO keyboard
modes:
• Unison mode with and without Retrigger
• Split mode with and without Retrigger
• Two-voice polyphonic mode
SYNCING THE MINI-SEQUENCER WITH A MIDI DEVICE
The TVS-PRO mini-sequencer can be synchronized to and triggered by an external MIDI device. When the
sequencer is driven by MIDI CLOCK, it responds to MIDI START and MIDI STOP commands from the external
MIDI device.
To synchronize the mini-sequencer to an external MIDI device:
1. On the TVS-PRO, press MIDI CLOCK. The mini-sequencer will start when it receives an incoming MIDI
CLOCK signal. (You do not need to press RUN on the TVS-PRO.)
To multiply the mini-sequencer clock rate by a factor of 2 or 4:
1. Press SHIFT once, then press CLK.
2. Select the desired rate with the UP and DOWN switches in the SEQUENCE section. The number shown
will be +2 for double rate, +4 for quadruple rate and if desired, back to +1 for the default rate.
An external MIDI keyboard connected to the TVS-PRO can also be used to transpose sequences. Make sure that the KEYB TRANS
button is enabled on the TVS-PRO.
MIDI OUT
MIDI OUT information comes from two sources in the TVS-PRO:
• The TVS-PRO’s keyboard.
• The mini-sequencer. (MIDI OUT information is active whenever the mini-sequencer is playing.)
In order to enable MIDI OUT from the TVS-PRO keyboard, you must turn on RE-TRIGGER
in the Keyboard Control section.
