9
Two-Voice Pro QuickStart Guide
Patch Panel
Patch Panel
The modular nature of the TVS-PRO is greatly enhanced by the 56-jack patch panel located at the top of the
front panel. This allows you to use standard 3.5 mm synthesizer patch cables to interconnect the various modules
and functions of the Two-Voice Pro with itself — or with external devices such as analog synths, modular systems,
and other gear — in interesting and creative ways
The patch panel contains the following signal inputs and outputs from the TVS-PRO modules:
• Keyboard/Bendbox/Mini-Sequencer modules: 10 outputs
• SEM A module: 10 inputs and 9 outputs
• SEM B module: 10 inputs and 9 outputs
• Also contained on the patch panel are two 1-in, 3-out mults
WHEEL OUT
VELO A OUT
VIB LFO OUT
VELO B OUT
S/H OUT
AFTERTOUCH
OUT
CV-A OUT
GATE-A OUT
IN
OUT1
OUT2
OUT3
CV-B OUT
GATE-A OUT
CV IN
SAW OUT
EXTMOD IN
PULSEOUT
CV IN
SAW OUT
EXTMOD IN
PULSEOUT
MULTS
VCO 1
VCO 2
CV IN
LP/HP OUT
CONTROL IN
EXTMOD IN
BP OUT
LFO OUT
VCF
VCA
LFO TRIG
LFO
ENV OUT
GATE IN
ENV 1
ENV OUT
GATE IN
ENV 2
The patch panel
Even if you just use the patch panel to make connections within the Two-Voice Pro itself you can create many inter-
esting sounds. You won’t break anything by making “wrong” connections here, so experiment!
Here are a few suggestions for patch connections:
• Connect
WHEEL OUT
to VCF
CV IN
to control filter cutoff with the Mod Wheel.
• Connect
S/H OUT
to VCF
CV IN
to control filter cutoff with sample & hold. Sample & hold start and rate are controlled by
the sequencer clock, so press
RUN
and turn the
CLOCK
knob to set the rate.
• Connect
PULSE OUT
from VCO 1 to VCF
CV IN
to perform audio-rate modulation of the filter.
• Connect
PULSE OUT
from VCO 1 to VCO 2
CV IN
to perform frequency modulation (FM) of oscillator 2.
• Connect LFO OUT to VCA
CONTROL IN
to create a tremolo effect. Rate is controlled with the LFO knob.
