Model ESMH Motorized Test Stand
4
4 SAFETY
TIPS
■
Wear eye and face protection when testing. Although the ESMH
has relatively slow moving mechanisms, be aware of the dangers
posed by potential energy that can accumulate in a sample during
testing.
■
Keep away from the moving parts of the test stand.
■
Never operate the test stand if there is any visible damage to the
power cord or the control unit. The ESMH is powered by
110/220V AC current that is present in both the power cord and
the control unit. Any contact with this high voltage can cause seri-
ous injury or even death.
■
Ensure that the control unit is kept away from water or any other
liquids at all times.
■
Make sure the electrical outlet powering the test stand has local
earth ground (3-hole outlet).
■
Opening up the cover of the control unit is not recommended, as
there are no user-serviceable parts inside. If you wish to open it,
be sure to disconnect power before doing so. If any repairs are
needed, contact Mark-10 or your distributor.
5 SETUP
Mounting to a workbench
Place the ESMH on a clean, flat and level work area that meets the criteria out-
lined in the work area safety instructions. For accurate readings, the area
should be free of vibrations.
If desired, the test stand can be mounted to the work area with four 5/16
screws.
