Series TT01 Digital Cap Torque Testers
User’s Guide
9
8.3 Set Point Indicators
When set points are enabled, the following indicators are shown to the left of the primary reading:
– the displayed value is greater than the upper load
limit (NO GO HIGH)
– the displayed value is between the limits (GO)
– the displayed value is less than the lower load
limit (NO GO LOW)
Note:
Set point indicators reference the displayed reading, not necessarily the current live load.
9 DATA MEMORY AND STATISTICS
Series TT01 testers have storage capacity of 1,000 data points. Readings may be stored, viewed, and
output to an external device. Individual, or all, data points may be deleted. Statistics are calculated for the
data presently in memory.
Individual data points may be saved to memory by pressing the
DATA
key, or automatically via the
Break
Detection
function, whichever is enabled. Refer to the
Communications
section for details. Once data
storage has been enabled, the data record number
0000
will appear below the primary reading in the
home screen. The record number will increment each time
DATA
is pressed or the automatic data
storage function is activated. When memory is full the message “MEMORY FULL” will be flashed at the
bottom of the display and a double audio tone will be sounded.
To view, edit, and output stored readings and statistics, select
Memory
from the menu. The screen
appears as follows:
9.1 View Data
All the saved data points may be viewed. The record number is displayed, along with the corresponding
value and presently set unit of measurement. Any readings may be deleted individually. To do so, scroll
to the desired reading and press
DELETE
. The letter “D” will appear to the left of the record number,
indicating that the gauge is in
Delete
mode, as follows:
0001 2.458 lbFin
0002 2.224 lbFin
0003
2.446 lbFin
0004 1.890 lbFin
D
0005 2.098 lbFin
0006
1.998 lbFin
0007 2.042 lbFin
MEMORY
View Data
View Statistics
Output Data
Output Statistics
Output Data & Stats
Clear All Data
