Series TT01 Digital Cap Torque Testers
User’s Guide
22
If the password has been misplaced, it can be reset. Press
ENTER
to generate a
request code
. The
request code
must be supplied to Mark-10 or a distributor, who will then provide a corresponding
activation code
. Enter the
activation code
to disable the password.
13 OTHER SETTINGS
13.1 Automatic Shutoff
The tester may be configured to automatically power off following a period of inactivity while on battery
power. Inactivity is defined as the absence of any key presses or load changes of 100 counts or less. To
access these settings, select
Automatic Shutoff
from the menu. The display will appear as follows:
Select
Disabled
to disable automatic shutoff. Select
Enabled
to enable it. The length of time of inactivity
is programmed in minutes via the
Set Minutes
parameter. Available settings:
5-30,
in 5 minute
increments.
Note:
If the AC adapter is plugged in, the tester will ignore the
Automatic Shutoff
setting and remain
powered on until the
POWER
key is pressed.
13.2 Backlight
Several initial settings are available upon powering on the tester. To access these settings, select
Backlight
from the menu. The display will appear as follows:
Select
Off
for the backlight to be off upon powering on the tester.
Select
On
for the backlight to be on upon powering on the tester.
Select
Auto
for the backlight to be on upon powering on the tester, but will shut off after a period of
inactivity (as defined in the
Automatic Shutoff
sub-section). The backlight will turn on again when activity
resumes. The length of time of inactivity is programmed in minutes via the
Set Minutes
parameter.
Available settings:
1-10
, in 1 minute increments.
Note:
If the AC adapter is plugged in, the tester will ignore these settings and keep the backlight on.
Selecting the
On
or
Off
setting in the
Backlight
menu will manually turn the backlight on or off.
BACKLIGHT
Off
On
*
Auto
Set Minutes
1
AUTOMATIC SHUTOFF
*
Disabled
Enabled
Set Minutes
5
