Series TT01 Digital Cap Torque Testers
User’s Guide
5
4 HOME SCREEN AND CONTROLS
4.1 Home Screen
No. Name
Description
1 Measurement
direction
indicator
– indicates clockwise direction
– indicates counter-clockwise direction
These indicators are used throughout the display and menu.
2 Peaks
The maximum measured clockwise and counter-clockwise readings. These
readings are reset by pressing
ZERO
or by powering the tester off and on.
3 Primary
reading
The current displayed load reading. See
Operating Modes
section for
details.
4 Units
The current measurement unit. Abbreviations are as follows:
ozFin – Ounce-inch
lbFin – Pound-inch
lbFft – Pound-foot
Ncm – Newton-centimeter
Nm – Newton-meter
5 Load
bar
Analog indicator to identify when an overload condition is imminent. The bar
increases either to the right or left from the midpoint of the graph. Increasing
to the right indicates clockwise load, increasing to the left indicates counter-
clockwise load. If set points are enabled, triangular markers are displayed for
visual convenience. This indicator reflects the actual load, which may not
correspond to the primary reading (depends on operating mode). The
ZERO
key does not reset the load bar. See
Operating Modes
section for details.
6 Mode
The current measurement mode. Abbreviations are as follows:
RT – Real Time
PCW – Peak Clockwise
PCCW – Peak Counter-clockwise
See
Operating Modes
section for details about each of these modes
7
Number of stored
data points
The number of stored data points in memory, up to 1000. Displayed only if
Memory Storage
is enabled for the
DATA
key.
8
Battery / AC
adapter indicator
Either the AC adapter icon or battery power icon will be shown, depending on
power conditions. Refer to the
Power
section for details.
1
2
4
5
6
8
9
10
3
7
