Mark-10 TSTM-DC, User Manual

Series TSTM-DC Test Stands    

   User’s Guide

10

Default setting: off 
Available settings: off, on 

Label 

Description 

+ or –

Cycles through the available settings 

ENTR

Returns to the Test Function Setup menu 

ESC

Exits the function without saving changes 

Note:

If 

AUTO RETURN

 is turned 

on

, 

CYCLING

 is automatically turned 

off

 and the 

KEYS

 function is 

automatically set to 

MAINTAINED

 mode. See following pages for details on the 

CYCLING

 and 

KEYS

functions. 

 
4.3 Cycling (CYCLES)

This setting allows the user to configure the number of CW and CCW cycles through which the torque 
plate will sequence. One cycle consists of the torque plate moving to a limit (torque set point, 
angle/degree limit, or various event completions in the M7I,) whichever occurs first, at the specified 
speed, stopping for the specified amount of dwell time, and returning to the other limit at the specified 
speed.  
  

Default setting: 00000 (off) 
Available settings: 00000 – 99999 

A U T O    R E T U R N      o f  f 

E S C        −      +      E N T R 

C Y C L E S :          0 0 0 0 0 

E S C        −      +      E N T R 

Label 

Description 

+

Increases the number of cycles in increments of 1. Holding down 

+

will increment at an increasingly faster rate. If 99999 is reached 
the next number will be 00000 and continue incrementing.

–

Decreases the number of cycles in increments of 1. Holding down 

–

 will decrement at an increasingly faster rate. If 00000 is reached 

the next number will be 99999 and continue decrementing.

Press and hold 
+ and –

simultaneously

If pressed and held for 2 seconds or longer the number of cycles 
will change to 0.  

ENTR

Returns to the Test Function Setup menu

ESC

Exits the function without saving changes