Mark-10 TSTM-DC, User Manual

Series TSTM-DC Test Stands    

   User’s Guide

17

2.  Cycling Mode: 

3.  PC Control Mode

Appears the same as in Basic and Auto Return modes. 
 

Label 

Description

menu

Enters Test Function Setup 

min

Sets speed to minimum speed. Will not appear when a 
password has been set.

max

Sets speed to maximum speed. Will not appear when a 
password has been set.

set

Sets speed to the programmed value.

Pressing 

menu

 will enter Test Function Setup. If a password has been programmed, the display 

will prompt the following:  

The password is a four-digit number. Press 

+

 or 

–

 to increment or decrement the number. Once 

the complete password has been entered, press 

ENTR. 

If correct, the display will enter the Test 

Function Setup menu

.

 If the password is incorrect, the display flashes “INCORRECT 

PASSWORD”, and then reverts to Operating Mode. 

5.3 Basic mode

The test stand rotates clockwise when 

CW

 is pressed, and counter clockwise when 

CCW

 is pressed. 

When the test stand is in motion, an LED indicator on the button pushed will be illuminated. The 

KEYS

setting controls how test stand movement responds to the push of either of the directional buttons. The 
three settings are: 

1.   Maintained (default) 

The torque plate will rotate continuously once the button has been pressed. 
Subsequently pressing 

STOP

 will stop test stand motion.  

2.   Momentary

The torque plate will rotate only if the button is pressed and held. Releasing the button 
will stop rotation immediately. 

3.   Auto 

Holding down the button for more than 0.5 seconds will enter 

Momentary

 mode, at which 

time an audible indicator will sound and the LED indicator on the button pushed will be 
illuminated. A short tap on the button will operate the test stand in 

Maintained

 mode. 

Pressing 

STOP

 during 

Maintained

 mode will stop rotation. To resume the test, press 

CW

or 

CCW

 again. 

Pressing 

EMERGENCY STOP 

will immediately stop rotation in any mode. To release, twist the button 

clockwise until it assumes its original position. To resume the test, press either directional button for two 
seconds.  

1  .  2 7                0 0 0 2 4

me n u    m i n   ma x    S E T

P A S S WO R D          0 0 0 0

E S C        −      +      E N T R