Mark-10 TSTM-DC, User Manual

Series TSTM-DC Test Stands    

   User’s Guide

22

1.  Ensure all cables are plugged in properly, as described in 

Setup and Safety 

section.  

2.  Ensure that the torque value has not exceeded the overload limits configured in the stand.  
3.  Ensure that instrument’s set points have been configured properly. Both set points must be 

enabled, regardless of test direction, with upper limit in the CCW direction, and lower limit in 
the CW direction. Refer to the indicator’s user’s guide for further instructions on configuring 
set points. 
 

9    SPECIFICATIONS

Torque capacity: 

TSTM-DC: 100 lbFin [11.5 Nm] 
TSTM-DC-1 / SP-2496 upgrade: 200 lbFin [22 Nm]*  

Speed range: 

TSTM-DC: 0.01 - 15 RPM [0.05 - 90°/s] 
TSTM-DC-2 / SP-2624 upgrade: 0.04 - 60 RPM [0.2 - 360°/s]*

Speed variation with load: 

±0% (Stepper motor driven)

Speed accuracy: 

±0.2% of setting

Rotational travel accuracy: 

±0.7° / 0.02 rev.

Rotational travel repeatability: 

0.1° / 0.01 rev.

Rotational travel resolution: 

0.1° / 0.01 rev.

Maximum slider travel: 

15.5" [394 mm]**

Slider travel rate: 

1.047" [26.6 mm] / lever revolution

Maximum angular travel: 

No limit

Manual adjustment: 

12º/knob rev

Angle dial resolution: 

2º 

Maximum slider travel: 

15.50” [394 mm]

Slider travel rate: 

1.05” [26.6 mm] / lever revolution

Power: 

Universal input 80-240 VAC, 50/60 Hz, 60W

Fuse type: 

1.2 A, 250V, 3AG SLO BLO

Weight: 

Vertical models: 35.5 lb [16.1 kg],  
Horizontal models: 29.5 lb [13.4 kg] 
Control panel: 2.7 lb [1.2 kg]

Environmental conditions: 

40 - 100°F [5 - 40°C], max. 93% humidity, non-condensing 

* Maximum torque decreases proportionately with speed. Examples:  
- Maximum torque at 60 RPM = 25 lbFin [2.8 Nm] 
- Maximum torque at 30 RPM = 50 lbFin [5.6 Nm]  
**A column extension will also extend the slider travel