Mark-10 TSTM-DC, User Manual

Series TSTM-DC Test Stands    

   User’s Guide

7

4.  The test stand should be serviced by a trained technician only.  

  
After the above safety checks and procedures have been performed, the test stand may be powered on 
and is ready for operation. 

3   OPERATION BASICS

3.1 Operational safety 

The following safety checks and procedures should be performed before and during operation: 

  1.  Always consider the characteristics of the sample being tested before initiating a test. A risk 

assessment should be carried out beforehand to ensure that all safety measures have been 
addressed and implemented. 

  
  2.  Wear eye and face protection when testing, especially when testing brittle samples that have the 

potential to shatter under torque. Be aware of the dangers posed by potential energy that can 
accumulate in the sample during testing. Extra bodily protection should be worn if a destructive 
failure of a test sample is possible. 

  
  3.  Keep away from moving parts of the test stand. Loose articles of clothing should not be worn. Long 

hair should be covered to avoid a hazardous situation.  

4.  In those applications where samples can shatter, or other applications that could lead to a 

hazardous situation, use of a machine guard is strongly recommended. 
 

5.  When the test stand is not in use, ensure that the power is turned off to prevent accidental 

engagement of any of the controls.  

 
3.2 Basic operation 

The slider’s position is adjustable along the column in order to engage and disengage the test sample. 
Move the slider lever clockwise to lower the slider’s position closer to the torque plate. The slider may be 
locked into position by tightening the friction brake knob located on the opposite side of the slider. 
  
The test stand may be operated by motor or by hand. To begin a motorized test, use the Control Unit to 
operate the test stand. For fine manual adjustment turn the knob on the motor drive in the desired 
direction.