Mark-10 TSTM-DC, User Manual

Series TSTM-DC Test Stands    

   User’s Guide

9

4  TEST FUNCTION SETUP

 
This section provides configuration instructions for each function.  
 
After pressing 

menu

, the initial Test Function Setup screen appears as follows: 

Label 

Description 

ESC

Exits Test Function Setup, reverts to Operating Mode 

< –

Scrolls to the previous function 

–  >

Scrolls to the next function 

ENTR

Selects the function, allowing it to be modified 

When the parameters have been configured as desired and are ready to be saved, press 

ESC

 to exit 

Test Function Setup. The screen will show 

SAVE CHANGES?

 Pressing 

YES

 will save the changes and 

return to the Operating Mode. Pressing 

NO

 will not save the changes and return to Operating Mode. 

 
Note: Changes can be made to an unlimited number of settings before saving.

4.1 Speed

Independent speeds can be set for both directions of movement.

Default setting: 10 RPM / 60°/s 
Available settings:  
TSTM-DC / TSTMH-DC:        0.01 - 15 RPM [0.05 - 90°/s] 
TSTM-DC-2 / TSTMH-DC-2: 0.04 - 60 RPM [0.2 - 360°/s] 
 

4.2 Auto return 

With this function, the torque plate moves to a limit (torque set point, angle/degree limit, or various event 
completions in the M7I), whichever occurs first, and stops. Then, the torque plate returns to the other limit 
and stops. The test speed is dictated by the setting described in the previous section. The return speed is 
locked to maximum speed.  
 

S P E E D :            2 0  .  0 0 

E S C      < −    − >      E N T R 

C W    S P E E D :      1 0  .  7  3 

E S C        −     +      E N T R 

Label 

Description

+

Increments the speed setting. Holding down 

+

 will 

increment at an increasingly faster rate.

–

Decrements the speed setting. Holding down 

–

 will 

decrement at an increasingly faster rate.

ENTR

Returns to the Test Function Setup menu 

ESC

Exits the function without saving changes