Model WT3-200 Wire Terminal Pull Tester
User’s Guide
17
10.4.2 Auto Output Settings
Select the output type. One, both, or no output types may be enabled. The display will appear as follows:
10.5 Analog Output
This output can be used for chart recorders, oscilloscopes, data acquisition systems, or any other
compatible devices with analog inputs. The output produces ±1 volt at full scale of the instrument. The
polarity of the signal is positive for compression and negative for tension.
10.6 DATA Key Functions
The
DATA
key can be configured to perform several functions. To configure the
DATA
key, select
DATA
Key
from the menu. The display will appear as follows:
Three options are available:
Selection
Function when pressing DATA
RS232/USB Output
Outputs data via the serial and USB ports
Mitutoyo Output
Outputs data via Mitutoyo (Digimatic) through the serial port
Memory Storage
Stores a reading to memory (refer to the
Memory
section for details)
Any combination of the above functions may be selected.
Trig. Threshold
Sets the percentage of full scale at which the break detection feature
becomes active. This threshold is provided to ignore peaks that can occur
during sample loading and unloading. Available settings:
5-50%
, in 5%
increments.
Auto Zero Delay
Sets the time delay before the primary and peak readings are zeroed.
Available settings:
1-60 sec
., in 1 sec. increments between 1-5 sec., in 5
sec. increments between 5-60 sec.
AUTO OUTPUT
SETTINGS
RS232/USB Output
Mitutoyo Output
DATA KEY
*
RS232/USB Output
Mitutoyo Output
Memory Storage
