12
standby
program –
display
intensity
disc repeat
prev/rew
next/f.fwd
stop/drawer
play
Nº 37 CD TRANSPORT
mode
pause
repeat
MADRIGAL AUDIO LABORATORIES
R
track repeat
time on disc
time remaing
1
2
4
6
7
8
18
17
16
14
13
11
9
10
12
15
5
3
Front Panel, Nº37
1
DISPLAY INTENSITY
Pressing this button varies the brightness of the
display
. Four brightness lev-
els are available, including “display off.” All front panel LED’s change their
brightness levels appropriately, except that they remain at the dimmest level
when the display itself is off.
When power is first applied to the Nº37 (or when power is restored after
an interruption), the display is automatically set to its brightest level.
Pressing the
display intensity
button once dims the display one level; press-
ing it again dims it further; pressing it again turns the display off. Pressing
display intensity
once more returns the display to its brightest level. (If
other Mark Levinson components in the system are “Linked” to the Nº37, all
display intensities can change in unison. See
Linked Functions
for more in-
formation.)
If the display is set to “off”, pressing any key will cause it to light at medium
intensity for approximately four seconds in order to display the action of
the key press.
2
INFRARED TRANSCEIVER (WITHIN DISPLAY)
Infrared commands transmitted from the remote control are received by a
receiver behind this section of the display. Remote control of the Nº37 may
be unreliable if there is not a clear line of sight between the remote control
and the receiver (if the remote is far off-axis, or if the Nº37 is within a cabi-
net, for example). In such a case consider using a third-party IR repeater to
route the signal to the IR input jack on the rear panel (see
Rear Panel, Nº37
,
below).
