6
Unpacking and Placement
Unpacking the Nº37
Unpack your Nº37 CD Transport and remove all accessories from the carton.
Important!
Keep all packing materials for future transport of your Nº37.
Shipping your new component in anything other than its
purpose-designed packing material may result in damage
that is not covered by the warranty.
Included with your new Mark Levinson product is a pair of knit, white gloves
designed to assist you in the initial unpacking and placement of your new pur-
chase. Please accept them as a token of our appreciation for having purchased
one of our products.
Remove the Transport Screws
Place the Nº37 CD Transport upside-down on a soft, clean surface. Remove the
transport screws from the bottom of the unit and save them with the packing
materials for future use.
Warning!
The transport screws must be removed before operating the
Nº37, since they immobilize the transport mechanism during
shipping to prevent damage. These screws must also be
replaced before shipping the unit.
Placement of the Nº37
The Nº37 should be placed close to your digital audio processor, thus keeping
interconnect cabling reasonably short. It may be placed on a shelf or in a cabinet
where it is convenient to operate, but should not be rack mounted, so as to leave
access to the rear panel power switch.
The Nº37 is designed for continuous operation—hence the standby button on
the front panel rather than a power button. However, a rear-panel power switch is
provided for your convenience should you want to disconnect the unit from the
AC mains (as when taking a vacation, for example).
Be sure to allow 3 to 4 inches of clearance above the Nº37 to allow heat dissipa-
tion through air circulation.
Drawings are included in this manual to facilitate special installations and custom
cabinetry (see
Dimensions
).
