Market Central, Inc.
R1000 NBS/NAC
Page 14 of 16
R1000 Switch SNMP Variable Definitions:
[r1000GangControl] – 1.3.6.1.4.1.9477.1.6.1
R1000 Switch gang control. This variable is used to control all channels in a unit. A unit may
contain 4, 6, 8, or 16 channels depending on model. On a “GET” of this variable, the unit will
respond as follows. If any of the channels in the unit are at position A, the status will be A. If all
of the channels in the unit are at position B, the status will be B.
[r1000KeyStat] – 1.3.6.1.4.1.9477.1.6.2
R1000 Key-Lock Switch Status. This is a read only variable. This variable can be used to
determine if the Key-Lock Switch is in the OFF or ON position.
[r1000PowerStat] – 1.3.6.1.4.1.9477.1.6.3
R1000 Power Status. This is a read only variable. If power is applied to both power entry
connectors, the Power Status will report “TwoSupplies”. If power is applied to only one of the
power entry connectors, the Power Status will report “One Supply Down”.
[r1000SoftwareVersion] – 1.3.6.1.4.1.9477.1.6.4
R1000 Software Version. This is a read only variable, and is limited to a maximum of 14
characters.
[r1000Name] – 1.3.6.1.4.1.9477.1.6.5
R1000 Identification String. The string is limited to a maximum of 14 characters.
[r1000Channels] – 1.3.6.1.4.1.9477.1.6.6
R1000 channel status, One character for (up to) sixteen channels in the unit. Channels which
are not used will be represented by an X character. This is a READ ONLY variable.
[r1000ChannelTable] – 1.3.6.1.4.1.9477.1.6.7
R1000 channel variable table. This variable is not directly accessible.
[r1000ChannelIndex] – 1.3.6.1.4.1.9477.1.6.7.1.1. ChannelIndex
R1000 channel number.
[r1000ChannelControl] – 1.3.6.1.4.1.9477.1.6.7.1.2. ChannelIndex
R1000 channel control. This variable is used to control the addressed channel.
NBS version - When set to A, the switch will connect channel A to C. When set to B, the switch
will connect channel B to C.
NAC version- A is the off position, B to common is on
[r1000ChannelName] – 1.3.6.1.4.1.9477.1.6.7.1.3. ChannelIndex
R1000 channel Identification String. The string is limited to a maximum of 14 characters.
[mcIpRequester] – 1.3.6.1.4.1.9477.2
The IP address of the remote entity that last accessed branch 1.3.6.1.4.1.9477.1. This variable
can be used to identify the last IP address to access any mcAgent variable. It is returned in the
authenticationFailure message.