Market Forge Industries ECO-TECH PLUS ETP-10G, Service Manual

adjustmEnts

All units are adjusted at the factory.  in case of operation problems at initial installation, check type of gas supply and mani-

fold pressure and compare it with information on the rating plate.

problEm

probablE causE

rEmEdY

BURnERS DO nOT 

cOmE On

a.  gas supply is off.
b.  Power switch is off.
c.  Probe not sensing water level.
d.  ignitor not functioning.
e.  combination gas valve not opening.

a.  Locate supply line and turn on.
b.  Locate switch on control panel and turn on.
c.  clean probes, check wiring.
d.  check ignition module, relay.
e.  check that control knob is in the On posi-

tion, check that 24 volts is at the gas valve.

BURnERS PRO-

DUcE cARBOn 

DEPOSiTS

a.  Incorrect orifice size.
b.  incorrect gas supply.
c.  incorrect gas pressure.

a.  check size and correct.
b.  check size and correct.
c.  check gas pressure at manifold.  correct if 

necessary.

FLASh BAcK

a.  Burning inside mixer tube.
b.  incomplete combustion.
c.  Sooting of burner.
d.  mislocated ignitor.

a.  Reduce primary air.
b.  increase burner input.
c.  increase primary air.
d.  Adjust ignitor.

 warninG

at least twice a year, have an authorized 

service person clean and adjust the unit for 

maximum performance.

 warninG

adjustments and service work may be per-

formed only by a qualified technician who is 

experienced in, and knowledgeable with the 

operation of commercial Gas cooking Equip-

ment.   However, to assure your confidence, 

contact your authorized service agency for 

reliable service, dependable advice or other 

assistance and for genuine factory parts.

 caution

shut off main electrical power to unit.

door GasKEt rEplacEmEnt

The cooking compartment door gaskets are made of a 

silicone-type rubber material that is very durable but sub-

ject to wear during normal operation.  Should the gasket 

leak replace it.
1.  Open the cooking compartment door.
2.  Remove the four screws on the outside of the door 

frame, and remove the door panel assembly.

3.  Remove the six screws from the gasket plate in the 

door panel assembly.

4.  Remove the gasket plate and the door gasket from 

door panel.

5.  install the new door gasket to the door panel.  Re-

place the gasket plate and six screws.

6.  Reassemble the door panel assembly in the door 

frame using the four screws.

7.  gasket replacement is now complete.
Door may be difficult to close until gasket has compressed 

to conform to opening.  Leaving door closed overnight will 

compress gasket.

ExtErior panEl rEmoval

 warninG

to prevent hazard in servicing the cooker, be 

certain that the steam supply boiler is shut 

down, the cold water shut-off valve is closed, 

and the electrical disconnect circuit breaker 

for the cooker/boiler unit is off before re-

moving side panels.

Access to all internal plumbing and electrical assemblies 

is from the right side.  The right-side panel is removed by 

removing the bottom screws from panel.  gas controls are 

located in the lower cabinet and are accessible from the 

front of the unit.