13
DESKTOP PRINTER SERVICE MANUAL
10.
Unclip the white wire clip that connects wires between the plastic extruder and the printer.
11.
Remove the plastic extruder from the printer. Take care not to remove the supporting bracket.
Replace A1095 extruder
1.
Place the new plastic extruder in the bracket on the printer chassis where the old extruder sat.
2.
Re-attach the wires between the extruder and the printer by reconnecting the white 4-wire connectors.
3.
Place the screws and lock washers from the old extruder into the holes on the bracket and tighten them
using the 2.5mm hex key.
4.
Slide the fiber feed tube through the channel at the bottom of the new plastic extruder, toward the front of
the printer.
5.
Slide the metal insert from the fiber feed tube into the V-shaped groove on the right side of the fiber
extruder and use the 2mm hex key to tighten the screw.
6.
Reinstall the plastic Bowden tube to the front-facing side of the plastic extruder and tighten the
thumbscrew.
7.
Reinstall the plastic feed tube to the rear of the plastic extruder.
8.
Power on the printer and reload materials. For more information, see
Loading Plastic
and
Loading Fiber
,
if applicable, in the
User Guide
.
