CONFIDENTAL. DO NOT DUPLICATE OR REDISTRIBUTE
Pre-Install Guide_2.0.0 | September 11, 2018
3
3
Note the pallet marking ‘FRONT.’ When you open the
crate, be mindful of the two doors on the front face
of the Metal X printer.
Once the shipping crate is safely placed in the uncrating
area and a clear path to the operating location is
available, begin to unpack the crate.
1. Unscrew and remove the top of the shipping crate.
Before you uncrate and transport your Metal X printer, you must comply with the
site requirements in the
Metal X System Facilities Guide
.
Exercise caution when moving the device; the printer weighs approximately 130lbs
and must be placed on an appropriate table, desk, or stand with appropriate clearance
on all four sides. (See the
Facilities Guide
for details.)
Before uncrating your Metal X printer, make sure you have a clear path from the
10’x10’ uncrating area to the install location. You will need a power drill (Phillips #2
bit) for uncrating and a knife or pair of scissors.
Always perform safe two-person lifts from the bottom of the device when moving
the Metal X printer.
Do not attempt to carry the device singlehanded.
METAL X
PRE-INSTALLATION GUIDE : METAL X SYSTEM