marklin 22184, Operating Instructions Manual

7

Function 

•  Built-in electronic circuit for operation with a conven-

tional DC power pack (max. ±12 volts), Trix Systems, 

Trix Selectrix or NMRA DCC digital systems.

•  Automatic system recognition between digital and 

analog operation. 

•   No automatic system recognition between Selectrix 

(SX) and DCC. 

•  Headlights for the locomotive change over with the 

direction of travel. They can be turned on and off in 

digital operation. 

Notes on digital operation: 

•  This locomotive comes from the factory programmed 

for the digital address “01” (Selectrix) / “03” (DCC). 

Number of speed levels that have been set:  28 (DCC) 

and 31 (Selectrix).

•   The first time the locomotive is used in a digital 

system (Selectrix or DCC), the decoder must be set 

for this digital system. To do this, the decoder must be 

programmed

 once in 

this

 digital system. 

•  Information about DCC Operation:  

The setting done at the factory 

does not

 permit opera-

tion with opposite polarity DC power in the braking 

block. If you want this characteristic, you must do with-

out conventional DC power operation (CV29 / Bit 2 = 0). 

The operating instructions for your central unit (example: 

Mobile Station) will give you exact procedures for setting 

the different parameters. With many systems the values 

set at the factory can be read in the programming mode.

Safety Information 

•  This locomotive is only to be used with the operating 

system it is designed for.

•  This locomotive must not be supplied with power 

simultaneously by more than one power source.

•  Please make note of the safety information in the 

instructions for your operating system.

The feeder track must be equipped to prevent inter-

ference with radio and television reception, when the 

locomotive is to be run in conventional operation. The 

611 655 interference suppression set is to be used for 

this purpose. The interference suppression set is not 

suitable for digital operation. 

No warranty or damage claims shall be accepted in those cases where 

parts neither manufactured nor approved by Trix have been installed in 

Trix products or where Trix products have been converted in such a way 

that the non-Trix parts or the conversion were causal to the defects and / 

or damage arising. The burden of presenting evidence and the burden of 

proof thereof, that the installation of non-Trix parts or the conversion in or 

of Trix products was not causal to the defects and / or damage arising, is 

borne by the person and/or company responsible for the installation and / 

or conversion, or by the customer.