10
Betrieb • Operation • Fonctionnement • Exploitatie
Setting Locomotive
Parameters with the
Control Unit
1. Requirement: Setup as
in diagram 1. Only the
locomotive to be changed
can be on the track.
2. Press the “Stop” and
“Go” at the same time
until “99” blinks in the
display.
3. Press the “Stop” button.
4. Enter the address „80“.
5. Hold the speed cont-
rol knob in the reverse
direction position con-
stantly. Press the
“Go” button while
you do this. The
headlight on the
locomotive will
blink. If no, repeat
starting at Step 2.
6. Enter the register number
for the parameter to be
changed (=> List 1).
7. Activate the direction
reversal.
8. Enter new value
(=> List 1).
9. Activate the direction
reversal.
10. End the procedure by
pressing the “Stop”
button. Now press the
“Go” button.
Important: On the 1st address
is changed, when changing the
locomotive’s address. The 2nd
address is always the following
address.
=> Maximum value for the 1st
address is 79.
Diagram 1
1
1
99
1
2
80
1
80
1
2
1
01
01
1
1
2
10
10
1
List 1: parameter
Register Number
Value
01
01 - 79
Address
03
01 - 63
Acceleration delay
04
01 - 63
Braking delay
05
01 - 63
Maximum speed
08
08
Reset to series values
63
01 - 63
Volume
