16
Assigning a Converter Address
The 6021 Control Unit can only put out the addresses
1 - 80. A converter address 1 - 80 must be assigned in
order to be able to Control locomotives with decoder
addresses greater than 80.
Example: A locomotive with a “programmable mm2
decoder“ is set for address 146. You can give this
locomotive a converter address (1 - 80) so that it can be
Controlled with the Control Unit.
With an mfx locomotive there is the advantage that
you do not have to delete the preset Motorola address
(if this address is already occupied). Instead, you can
also use this locomotive by assigning a free converter
address.
!
A converter address may not be used for multiple
locomotives!
All converter addresses not in use are managed by
the Connect 6021 as standard Motorola addresses. All
locomotives with a Motorola address from 1 to 80 can
be Controlled from the Control Unit without changing
the converter address.
!
Changing the converter address is not transmitted to
the locomotive decoder!
Summary of Contents for 60128
