11
• Programmable addresses by means of CVs
1-2.040
DCC
• Characteristics can be changed by means of CVs
• Power supplied by means of the digital current circuit
Signal Installation
The signal must be programmed before actually installing it.
The following work steps may be done only when there is no
voltage present:
Setting the address and the mode of operation with the DIP switches:
• Setting the mode of operation with DIP Switch 10
Switch 10 off = fx (MM) / mfx
Switch 10 on = DCC
• fx (MM)/DCC Setting the address with DIP switches (See
table starting on Page 22)
!
Please note:
• Always do settings with the DIP switches when there is no
voltage present. The signal does not recognize the current
switch settings until the voltage is turned on.
• Basically, 2 addresses (pairs of buttons) are required
to
switch the 76496 and 76497 signals
. The second address is
assigned automatically as a sequential address. This sequen
-
tial address
cannot be selected at will
.
Programming with the CS 2
fx (MM)
The CV programming must be done on the programming track.
Only one signal
may be connected to the programming track
at
a time
.
The following CVs can be changed in fx (MM): CV 40, 45, 46, 48 ,
50, 52 and 54.
The address for the distant signal located on the mast, the
next address on the 76495, on the 76496 and 76497 the address
after the next
address, is assigned automatically
. This address
cannot be changed.
During the programming procedure, the signal light will blink.
During programming with the Central Station, by contrast the
signal is switched. After the end of the programming procedure,
the signal is set at “Go”.
An fx dummy locomotive with the address of the signal must be
entered before programming with the Mobile Station 2. Activate
the signal once. After that, change the desired CV settings and
switch the signal one more time.
The procedure for programming with the 6021 Control Unit can
be found at www.maerklin.de -> Tools & Downloads ->Tech
-
nische Informationen.
Please see the operating instructions for the control devices in
question for programming with other devices.
DCC
CV programming must be done on the programming track.
Only
one signal
may be connected to the programming track
at a
time
.
The signal will blink for monitoring purposes during the data
transfer.
Please see the operating instructions for the control devices in
question for programming with other devices.
