marklin Connect-6017, Manual

6

3. 6017 as the first Booster: Set switch 3 of the 4 coding 

switches to “ON”. Plug in the power transformer. Use 

only the corresponding Märklin plugs. (Already installed 

at the factory on the 60052/60055 transformer, the 

966181/966191 transformer from the starter sets, and 

on the 610 718 connecting cable).

4. Plug in the Booster 

connecting cable 

between the  

Connect-6017 and 

the Booster.  

Caution: Pay atten-

tion to the position 

of the plugs.  

Connect-6017 and 

6017 Booster:  

The cable goes up. 

6015 Booster: The cable goes down (!).  

If several Boosters are being used, each one of these 

will be connected in turn with the multi-pin connecting 

cable to the socket on the Booster, which has just been 

connected to the system.  

Caution! Also pay attention here to the correct position 

of the plugs.

5. Plug the power cords for the transformers into the 

household current. 

Operating Notes:

1. The Central Station is switched to “Stop”: 

 => The Connect-6017 also switches the Boosters off 

(LED pilot lights off). 

The Central Station is switched to “Go”:  

=> The Connect-6017 switches the Boosters back on 

(LED pilot lights on). 

2. Short circuit or an overload in the Connect 6017 area 

of the layout:  

Only the Connect-6017 switches off (LED pilot lights 

off). The Central Station remains on! 

To turn the Connect-6017 on again: 

1. Find and correct the cause of the short circuit / 

overload. 

2. Press the “Stop” button on the Central Station. 

3. Press the “Go” button on the Central Station.

3. Mfx locomotives in the Connect-6017 area of the  

layout cannot send data to the Central Station.  

Reprogramming of these locomotives can therefore  

not be done in this area of the layout.    

booster

6017    6015

6015

6015

01