Marks USA • www.marksusa.com • 631-225-5400 • 800-526-0233 • Fax: 631-225-6136 •
© 2008, Marks USA
Page 3
Figure 11
Figure 12
Installing the Biometric Fingerprint Reader
Figure 13
1. Place inside gasket over the support plate. Make sure
all cables come through the opening in the gasket.
Follow numbers for cable connections as you will see
in step 14.
1. Place Inside back plate over lock, with all cables coming
through the opening in the back plate.
2. Install inside rose on lock, over back plate, and fasten to
outside rose lightly with its two mounting screws.
Figure 14
1. Attach inside support plate to outside fingerprint reader
with four screws. Make sure all cables come through
the opening in the support plate.
1. Attach all cables to inside
module as shown.
Figure 15
1. When finished,
the cable connections
should be connected
as shown.
Figure 16
1. Install inside module onto
support plate with two screws
inside battery compartment,
and one screw at the bottom
of the module.
2. Tighten the two rose screws.
3. Snap on inside rose cover.
Make sure bumps on cover
align with dimples in rose.
2 Screws are
located here
1 screw is
located here
under
the bottom
of the unit
Figure 17
1. Install 4 “AA” batteries
and battery cover.
You are now ready
to program the lock.
