Button
Description
Operation
SET
LCD Screen Lamp Turns ON for
Press and Hold for 1 Second
Five Seconds
1 Melody Sounds to Confirm
SET
Timer Programming Mode
Press and Hold for 3 Seconds
2 Melody Sounds to Confirm
SET
Power Save Mode
Press and Hold for 5 Seconds
1 Melody Sounds to Confirm
SET (3X)
Clear the Flash Icon and Melody Sound
Press within 3 Seconds
on the LCD Screen
SET & LOCK
Button Lock Enabled/Disabled
Press within 3 Seconds
SET & UNLOCK
Melody/Vibrate Mode
Press within 3 Seconds
Program Count Down Timer
Press within 3 Second Cycles
SET
(10 m, 20 m, 30 m, 1 hr, 1.5 hr, 2 hr)
Leave the Buttons Starting Count
Down then Timer Icon Flashes
SET
Enable/Disable Beep Sound While
Press for 2 Seconds
Pressing Button
SET - SET -
Display Illumination On/Off
3 Seconds between “SET - SET”
and Hold for 2 Seconds
SET -
Switch Between 1st Car RF Control and
Hold for 2 Seconds
2nd Car RF Control
+
+
19
Programming the LCD Transmitter
Screen Lamp On
+
+
Press and hold the “SET” button one second, with the melody sound and the LCD screen lamp
will turn on for 5 seconds.
While in the Power Save Mode, the LCD transmitter uses “0” current to save the battery power.
1. Press and hold the “SET” button for 5 seconds. One melody will sound from the transmitter
and the LCD will show “SAVE”. You are now in the Power Save Mode.
2. Under the Active Arming Mode and Disarm Mode. Turn the ignition switch to the “ON” position.
The LCD remote transmitter will automatically enter the Power Save Mode.
Press any button on the LCD transmitter to exit the Power Save Mode.
Press the SET button 3 times within 3 seconds and it will clear the flashing icon and melody
sound on the LCD transmitter.
Power Save Mode
Exit Power Save Mode
Clear the Flash Icon and Melody Sound
