Combimatic_v2_EN_210315 25
Combimatic
Operation
5 .2 .5 Tighten the chain
1 . Loosen the locking handle and move the
tensioner upward or downward to make enough
room to position the chain .
2 . Lift the tensioner arm (there is a quick release
function) and place the chain below the
tensioner roll .
3 . Lower the tensioner arm to its bottom position .
4 . Move the tensioner downward until the chain is
tightly secured in its position . There should be a
gap of about 10–15 mm between the
pneumatic-piston nut and pneumatic piston,
where the piston should be visible .
10-15 mm
