© MARMITEK
6
PAIRING AND CONNECTING
The Bluetooth amplifier must be paired with your Bluetooth-enabled device in
order to be able to stream audio. To pair the amplifier, power up the amplifier
(with volume control).
Then go to the wireless settings of your Bluetooth
device and select "Scan for Bluetooth devices". If in Windows, select "Add
New Device" in the Bluetooth tab.
Once the amplifier is shown as a headset with the name "BoomBoom 460",
confirm the pairing on your device. Next your Bluetooth device will
automatically connect to the ampl
ifier. If it doesn‘t, manually select "Connect".
If streaming from Windows, note that Windows will install drivers during the
pairing. Manually connect to the amplifier by right-clicking the headset symbol
and selecting "Connect" if Windows does not connect automatically.
After the pairing is complete audio can be streamed to the amplifier from your
device.
RECONNECTING TO THE AMPLIFIER
If the amplifier or your device is switched off, the connection will be dropped.
When the amplifier is switched back on, it will automatically pair to the last
device it was connected. or.you can manually reconnect to the amplifier by
revisiting the Bluetooth settings of your device. Then simply select the
amplifier and select
“
Connect". The audio streaming will resume. In Windows,
right-click the headset symbol and select "Connect".
POWER/ BLUETOOTH INDICATOR LED
The BoomBoom 460 has a multicolour indicator led. (red and green).
Red: power ON
Green: Bluetooth ON.
Red and green alternate flashing quick: Pairing mode.
Red and green alternate flashing slow: Bluetooth connection.
WIRED CONNECTION
This BoomBoom 460 can also be used as a conventional Wired Stereo
amplifier with Direct Line-In to your Panel TV or other Audio Devices simply
by connecting the 3.5mm Audio Cable from the rear of the BoomBoom 460 to
your Music Source.
