7
To control a lamp using the ActiveHome program, follow these steps:
Please read through these installation steps completely before you start to
install a Lamp Module.
1. Select a nearby lamp (40-300W), one that uses a standard light bulb, and
make sure its on/off switch is switched on.
2. Unplug the lamp from the wall outlet and plug it into a Lamp Module.
3. Plug the Lamp Module into a nearby AC outlet. If this outlet is controlled by a
wall switch, make sure the wall switch is turned on.
4. If you have not already done so, start your ActiveHome software by double
clicking on the ActiveHome icon.
5. Using your mouse, click the switch of "My Lamp" as shown on your computer
screen. There may be a delay of one or two seconds from the time you click the
"on screen" module switch and when the light actually turns on. You can also
dim the lamp by moving the slide switch up and down.
Summary of Contents for CK13
Page 1: ......
