INSTRUCTIONS FOR USE
USING THE WIZARD
After you insert the batteries and choose “English,” the Setup Wizard
screen appears. You can exit the Wizard at any time by pressing the
HOME key (located just below the screen). Follow the instructions on
the Wizard screens to familiarize yourself with the OK, Back, and Side
Keys.
You can go back and forth through the Wizard, but once you’ve set up your devices and
quit to save the settings, you won’t see the Wizard again unless you do a Master Reset.
To do a Master Reset:
Press the
HOME
key,
Setup
,
More
,
Advanced
,
Clear
Settings
,
More,
and then
Master Clear
. Note this will erase everything you have set
up in the remote.
SETTING UP YOUR DEVICE
After you’ve been through the Wizard for the first time, the screen shown to the right
appears. This is the start of the Wizard for setting up your devices (TV being the first
one).
If you know your brand of TV, select
Yes
, which results in a faster
search for your TV’s code. Selecting
No
searches the complete library
of TV codes, rather than just the codes for your brand of TV.
Pressing the Side Key for
Yes
takes you to the screen that shows the
most common brands. Use the Side Keys to select your brand of device.
If your brand isn’t shown, you can press the Side Key adjacent to Next
to show more brands, (shown alphabetically); or press the Side Key
adjacent to
Back
to go back to the previous screen of brands.
After you select your brand, the
next
screen tells you to point the remote at your TV
and keep pressing
Power
until it responds.
Pressing Power sends the Power code to your TV, and the screen shows that you’ve sent
code 1 of xx (xx will vary by brand). Keep pressing
Power
until your TV responds and
then press
Save
. (You can press the Side Key adjacent to
Last Code
if you overshoot).
6
© MARMITEK
Summary of Contents for EASY ICON 10 RF
