Improperly wired vessels are beyond Marquis Corp. control and are not cov-
ered under the warranty. Other items beyond Marquis Corp. control include,
but are not limited to, damage resulting from: improper connections; accidents;
failure to follow procedures and instructions defined in the Marquis
®
printed
in
structions; cleaning agents; and natural occurrences including but not lim-
ited to rodent or insect infestation, mold, lightning and other acts of nature.
STARTUP PROCEDURE
Your vessel is equipped with solid-state Comfort Controls specific to your
vessel model. (See
VESSEL CONTROL OPERATION
for your specific spa
model.)
NOTE:
Your vessel has been filled and test-run at the factory. The first time
your vessel is filled with water, some discoloration from residual test water
may appear. This will disappear when the vessel is completely filled and the
filtration system is functioning.
WARNING:
Vessel must be completely filled with water before turning on
power. Test the water for the proper chemical balance and adjust as neces-
sary. Vessel Care products are recommended. To start your vessel, you
need chemical test strips. (See WATER TREATMEnT.)
PROPER CHEMICAL BALANCE IS IMPORTANT
for your safety and the
longevity of your vessel. In the case of relocating your vessel, it is impera-
tive to follow the instructions in the owner’s manual. These instructions must
remain with the vessel. Damage caused by relocating vessel is not covered
under warranty.
THERAPY PUMPS
Allow the vessel to circulate on high-speed (see VESSEL COnTROL OpERA
-
TiOn) for four to five minutes to discharge air from the plumbing system. Do
not expect hot water immediately from the jets; the heater will take several
hours to heat the water. Typically one degree per hour in most conditions.
Startup procedure for all models
1. Place vessel on a hard, flat, level surface. Make sure the power supply is
off.
2. Make sure the suction guard(s) in the footwell are in place and undamaged.
3. Open the equipment door. Tighten all disconnects and open all shut-off valves.
NOTE:
Keep the drain valves closed at all times except when draining the
spa (do not rely on the cap to stop the flow of water). Not doing so could
result in damage to the drain valve due to freezing water.
4. install filter cartridges. (See
INSTALLATION
INSTRUCTIONS
, Filter Cartridges.)
5. Fill water to 4’ marker lines shown on the inside walls of the vessel. DO
nOT OVERFiLL. The use of a Fill Filter is recommended, especially in ar
-
eas with high mineral content in the water.
6. Turn the power on.
starting your atv