WARNING:
Spa must be completely filled with water
before turning on power.
7. Your vessel is now in “pump priming” mode and a
“priming Mode” message displays in the LCD win
-
dow of the control panel. While in this mode the spa
appears idle, which lasts approximately four to five
minutes if not exited manually. To exit manually, press
the JETS 1 pad.
8. Allow the vessel to circulate on high-speed (see
SpA COnTROL OpERATiOn) for four to five min
-
utes to discharge air from the plumbing system.
Do not expect hot water immediately from the jets;
the heater will take several hours to heat the water.
9. At this time the vessel should have water flowing
from the jets. If the pump has not primed and the
water is not flowing from the jets after two min-
utes TURn OFF pOWER TO THE VESSEL and vent
air from the pumps by slightly opening the pump
unions located behind the equipment door. After
turning the power on again, the vessel initiates a
new priming mode. Repeat steps above.
10. The system requires approximately two minutes
of water flow to determine the water temperature.
After two minutes of water flow, the temperature
is displayed as actual water temperature. After you
have manually exited the priming mode (or allowed
the vessel to automatically exit) the LCD window
momentarily displays 100°F (38°C) and then the
display switches to - - °F.
11. The factory default setting for water temperature
is 100°F (38°C). Use the TEMp pads on the control
panel to set the water temperature to the desired
level. (See SpA COnTROL OpERATiOn.) it can take
up to 48 hours to heat the water to desired tem-
perature depending on the water temperature and
voltage of your vessel.
12. If water is not coming out of the jets, check to
make sure the adjustable jets are open. Simply turn
the jet face to open or close the jets.
starting your atv
Vent air by slightly
opening pump unions.
