CONTROL PANEL OPERATION INSTRUCTIONS
HOT KEYS
Using pump 1:
(Jets in seats and swim jets)
Pressing the Jets 1 button will turn pump 1 on low speed. Pressing a second
time will turn the pump on high speed. Pressing the button a third time will
turn the pump off. The pump will run for 15 minutes before shutting off or
switching to low speed. If the pump continues to run on low speed after the
15 minute timeout, the system is either calling for heat or has entered into a
filtration cycle.
Using pump 2:
(Swim jets only)
Pressing the Jets 2 button will turn pump 1 on low speed. Pressing a second
time will turn the pump on high speed. Pressing the button a third time will
turn the pump off. The pump will run for 15 minutes before shutting off or
switching to low speed.
Using pump 3:
(Swim jets only)
Pressing the Jets 3 button will turn pump 1 on low speed. Pressing a second
time will turn the pump on high speed. Pressing the button a third time will
turn the pump off. The pump will run for 15 minutes before shutting off or
switching to low speed.
LIGHT:
pressing the light button will turn the LED lights on. pressing a second time
will turn them off. if left on the LED lights will automatically turn off after 30
minutes. You can change the color of the LED lights by pressing the light
button repeatedly within 3 second intervals. Doing this will allow you to scroll
and choose a specific color or light sequence.
ALL QUIET SOAK FEATURE
Pressing the soak button activates a special feature that turns off all pumps
and heater allowing for a quite soak in the hot water. Pressing the button a
second time will restore the unit back to normal operation. If left on, the soak
mode will time out after 15 minutes and revert back to normal operation.
Note:
Periodically the pump/s may continue to operate for a short time
after pressing the soak button. This typically happens when the vessel is
in a heat cycle as the heater will need a short period to cool down before
stopping the water flow.
operating your atv
