get into it!
6. Turn the power on.
7. Your spa is now in “pump priming” mode and a
“Pr” message displays in the LCD window of
the control panel. While in this mode the spa
appears idle, which lasts approximately four to
five minutes if not exited manually. To exit
manually, press the TEMP+- pad.
8. At this time the spa should have water flowing
from the jets. If the pump has not primed and
the water is not flowing from the jets after two
minutes
TURN OFF POWER TO THE SPA
and vent air from the pumps by slightly opening
the pump unions. After turning the power on
again, the spa initiates a new priming mode.
Repeat steps above.
9. The system requires approximately two minutes
of water flow to determine the water tempera-
ture. After two minutes of water flow, the tem-
perature is displayed as actual water tempera-
ture. After you have manually exited the priming
mode (or allowed the spa to automatically exit)
the LCD window momentarily displays 102°F
(39°C) and then the display switches to - - °F.
10. The factory default setting for water tempera-
ture is 102°F (39°C). Use the TEMP+- pad on the
control panel to set the water temperature to
the desired level. (See SPA CONTROL OPERA-
TION, Temperature Display And Adjustment.)
Your spa heats at the rate of approximately one
degree per hour for 120V systems, and five
degrees per hour for 240V systems.
SPA COVER
When the spa is not in use, the spa cover should be
kept on the spa to retain the water’s heat and to
keep out dirt, leaves, etc. Your heater maintains a
constant water temperature between uses.
For your safety and convenience, the cover is
equipped with adjustable straps, safety locks, and
handles. Use the exterior handles to remove and
replace your cover. We suggest that you use the
safety locks to help keep out unintended users and
prevent the cover from being blown off in windy
conditions. Cover Companion™ and other cover
lifts are also available to assist you in cover removal.
See your Marquis Spas dealer for details.
starting your spa
Spa cover helps
maintain a constant
water temperature.
16
Use TEMP+- pad to set
water temperature.
