Mars CPU04, User Manual

13

Titan CPU Channel Mul  plexer - Connec  ons

Via direct Ethernet connec  on:

1.  If you are making a direct connec  on between the Titan CPU and a PC, you 
will need to reconfi gure the PC with a sta  c IP address on the same subnet as the 
CPU.

To determine the correct sta  c IP address for the PC, obtain the IP address of the 
CPU (the IP address is marked on the device). Use the same fi rst three octets of 
this address, but set the last octet to a diff erent number. For example, if the CPU 
is confi gured for “192.168.10.51”, you could set the PC to “192.168.10.61”.

For instruc  ons on changing the PC IP address, refer to:

h  ps://support.microso  .com/en-us/help/15089/windows-change-tcp-ip-
se   ngs

2.  With the sta  c address changed on the PC, and with no power applied to the 
Titan CPU, plugan Ethernet cable into the Ethernet port on the CPU and then 
connect the other end to the Ethernet port on the host PC.

3.  Follow steps 3-5 as described in the ‘Via a Network’ sec  on on the previous 
page.

Changing the IP Address

The Titan CPU IP address can be changed using the Titan CPU IP Address 
Programmer applica  on, which is available as a part of the Titan Service Pack. 
The Titan Service Pack can be obtained from the Downloads page on the 
Mars Labs website (www.marslabs.com).