2
3
Introduction
The Regenerator RG-1 is every modulation pedal you'll need in
one package. It is a stereo modulation pedal recreating six
different modulation modes for you to explore giving you full
control over the modulation time, modulation depth and
regeneration of every mode creating a truly awesome stereo
sound field.
Below is a complete run down of the Regenerator's features
for your information. We have also enclosed a number of
suggested settings to help guide you. It should be
remembered that these are only suggested settings and you
should really experiment as much as possible.
Features
1. 'In' Jack Socket
This is the input jack for connection to your guitar or to the
output of another effects pedal when linking pedals together.
2. 'Expression' Socket
An expression pedal can be connected to this socket to
control the modulation speed. Moving the pedal overrides the
speed control on the pedal allowing you to
increase/decrease the control as you perform.
Always use good quality shielded leads.
Always use 9V regulated DC supply with centre negative rated
at 80mA or above.
Although it may seem obvious the first action in achieving a
good effected sound (be it duration / compression etc.) is to
find the perfect bypassed sound. This will then allow the
correct level to be set with the effect unit to allow a cut or
boost in volume and a realistic tone.
On clean channels it is advisable to set the gain (or volume)
to a setting of no less than one quarter maximum so as not to
get unrealistic results due to any volume dependent tonal
shaping on the amplifier preamp.
Setting Up
ENGLISH
