7 of 12
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
WS2690revB
1. Press down handle and carefully remove the Cam
Locking Pin. Carefully raise and release the handle.
2. Place material to be cut on the table with the
finished side up and slide past the blade to the
desired length. Press flooring against the Bed
Fence and hold firmly in place to ensure a clean and
accurate cut. Press handle down until the blade
touches the material and then firmly press down on
the handle until the material is cut.
PRODUCT OPERATION
45 DEGREE CUTS
1. Remove the Bed Fence by pulling firmly up. Insert the fence into either of the angled holes for the desired cut.
DOUBLE CUTTING
Some materials may require the double cutting method to obtain a clean cut. For these materials, make your
first cut 1/4" longer than your mark. Then, make a second cut on your mark. This method will help produce
cleaner cuts on some materials.
CUTTING GUIDE
The MARSHALLTOWN Flooring Cutter is designed to cut a variety of materials. Some of the most common
materials are laminate flooring, engineered hardwood, luxury vinyl tile, luxury vinyl plank, vinyl composite tile,
fiber cement board siding, and more.
Note: DO NOT attempt to cut any solid wood, high pressure laminate, engineered hardwood with a Janka
Hardness Rating higher than 1200 or a rating higher than AC4.
Note: Even the approved materials may vary greatly in density and hardness. If extreme force is required to cut
a material stop immediately, as it could lead to damage to your cutter or injury. Attempting to cut unapproved
materials will void the warranty.
