4 of 8
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
WS2749revA
WARRANTY
This product is warranted to the original purchaser only, to be free of defects in material and workmanship
under normal use, for one year from purchase date. MARSHALLTOWN shall without charge for parts and labor,
repair or replace such parts which are found to be defective. All transportation charges for replacement parts
must be borne by the purchaser.
For warranty service, the product must be delivered, with proof of purchase date, to MARSHALLTOWN. Contact
MARSHALLTOWN Customer Service to determine the best method of delivering the product that is under warranty.
The delivery of the product must be made no later than 30 days after the expiration of the warranty period.
All implied warranties, including those of merchantability and fitness for a particular purpose, are limited to one
year from date of purchase by the original retail customer and to the extent permitted by law any and all implied
warranties are excluded and disclaimed after the expiration of such period.
Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitations of
incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty
gives you specific legal rights, and you may also have other rights, which vary from state to state.
Exclusion from this warranty:
1. All consequential damages, including pickup and delivery of the unit, communication, mileage charges
and/or rental of a replacement unit during repairs are not covered under this warranty, or are any loss of
income and/or other loss resulting from the failure of the product to function due to a warranty defect.
2. This warranty will not apply when the product becomes inoperative due to misuse, normal wear,
neglect, improper maintenance, accident or freight damage; has not been operated and maintained in
accordance with the instructions furnished in the Operator’s Manual; or has been altered or modified
without approval from the factory Service Department.
3. No parts or products are to be returned to the factory without prior written approval from the factory.
PRODUCT OPERATION
• Be sure to place the cutter on a flat and even surface when in use.
• Do not exert too much force on the cutter or tiles as this will cause tiles to break.
• After you cut tiles, be alert that the newly cut edge can be sharp.
To cut a straight line:
1. Place tile on base and slide until flush against the
guide. Adjust the square guide to desired position.
2. Place the cutting wheel on the rear edge of the tile
and slide the wheel forward by pushing the handle
down, scoring the tile as the handle is pushed
forward. It is important to make this scoring cut in
one continuous motion, scoring only once per tile.