5 of 6
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
WS2770
NOTES
1. Adjust the Hex Bolts & Nuts on the Sliding Block as desired to modify sliding pressure. Ensure both the left
and right sides are adjusted equally.
2. Before storage, lubricate the rail on the cutter with a few drops of light oil to prevent rust.
3. Replace the scoring wheel when cutting becomes difficult or the score line is not clean. This is a standard
wear part.
1. Adjust angle guide to desired angle and place the
guide against the tile.
3. Flip the breaker down and position slightly away
from the front edge of the tile.
2. Carefully lower wheel until it makes contact with
tile and then apply consistent pressure while
scoring full length of the tile.
4. Apply increasing downward pressure on handle
until the tile snaps.
To cut an angle:
REPLACEMENT PARTS
REF #
DESCRIPTION
PART#
Quantity
32484
SCORING WHEEL WITH FASTENERS - TC36
TC36SW
1
32485
GUIDE FENCE WITH THUMBSCREW - TC36
TC36GF
1
32486
BREAKER FOOT WITH FASTENERS - TC36
TC36BF
1
32487
EXTENSION ARM WITH BRACKETS & FASTENERS - TC36
TC36EA
2
